NanoKontrol2 scene settings gone on each power-up

larstwin · Post by **larstwin** » Tue Oct 04, 2011 7:19 am

Hi everyone,

Nice controller. Works fine with logic, traktor, live etc.

However, when I use the Korg Kontrol Editor and I write a custom scene to the NanoKontrol2 - this scene is gone on next power-up. I use this scene for Mainstage.

Anyone knows how to make my scene permanent in the Kontrol2.

Otherwise, I have to open the Korg Kontrol Editor each time and transfer the scene to the device...

Please let me know, if there is a solution out there...

Lars, Denmark

davc1 · Post by **davc1** » Wed Jun 27, 2012 6:01 pm

i have the same problem with my nanopad ...

it is recognized at start up of Kontroller software

i change the notes for the pads , write the Scene to the Nanopad ...

or at least it says it's writing the Scene into the nano memory ...

then i unplug it , and plug it into my Kronos ... and the Scenes are Not there ... ???

it does work to play the Chord Pads for the Karma ...

but that's not what i'm trying to do ... i'm trying to Assign the nanopad to play specific notes so i can pull up a Drum kit Patch on my Kronos and use the nanopads to program/play the drum sounds .. !!??

reading the manual it looks like this should work ... but i can't get the Scene data into the Nanopad .. ??????/

thanks for any help or suggestions ... i am not using any DAW , just the Kronos ...

Dave C.