Touchscreen trouble: how to save pcg without touching screen

tritonhaven · Post by **tritonhaven** » Tue Sep 04, 2012 11:17 am

Hi there,

My M3 has a lot of trouble with the calibration.
I tried a few times to calibrate it, but after 5 minutes it's off again.

It has become so bad that I even can't calibrate anymore (using global > ENTER+4). The below/right square won't become black when i touch it.

So... how can I save my pcg without touching the screen before I bring it to a repair center?

Any other suggestions are also welcome.

cheers,
Angelo

r12 · Post by **r12** » Tue Sep 04, 2012 11:53 am

you can save with the external PC editor

HardSync · Post by **HardSync** » Tue Sep 04, 2012 5:42 pm

If you are at all able to activate the SAVE tab via the bottom of the screen, then you can press the ENTER + 6 buttons together, which will bring up the save PCG dialog. Everything will be checked by default, however.

Most of the menu commands are accessible this way. For instance, ENTER + 5 brings up the save PCG and SEQ dialog.

You can give the above a try if you're not using the editor.

rpowell01 · Post by **rpowell01** » Thu Sep 06, 2012 1:45 am

Purchase you a pen for touch screen it will make a huge difference for you.

http://www.newegg.com/Product/Product.a ... -_-NA-_-NA

I need one myself because I have problems with my fingers being to big at times that causes me to open or select the wrong thing.