Help please - strange sequencer/note hold issue

[roly D]

Hi all. I am hoping for help that may avoid me potentially having to re-record a sequencer track.

I was working on a completely different song in sequencer mode. Having made good progress, I did a "save seq". All good - until I decided to have a listen to an earlier, completely different, song I had not worked on for a couple of weeks.

When this other song started, midi track 3 - which contained a brass part - sounded like it was running every note together. I eventually stopped that by pressing my damper pedal. However whenever I stop the song it reverts back to the "held note" problem.

After temporarily fixing it again I also noticed that it sounded the like the pitch of the track had changed. This time I jiggled the joystick and it seemed to knock it back into tune - again temporarily.

I have been into program mode to check if something had somehow happened to the program, which I had used stock-standard rather than editing. It seemed to be operating completely normally.

All other midi tracks in the song seem to be playing as recorded. It is just this track 3 that seems to have a ghost in the machine that I have no idea how I might have brought into existence...

Any assistance would be greatly appreciated. I have tried the good old "turn it off and back on again".

[X-Trade]

Have you tried recording the controller adjustments into the beginning of the track?

They probably have values saved in the actual MIDI playback data.

[roly D]

Thanks for the suggestion.

Now if I only knew how to do it...

[ronnfigg]

Try the manuals for guidance on how to do it.