korg pa3x mic input problem

omarnawabi · Post by **omarnawabi** » Mon Jan 13, 2014 2:56 am

Hey I used to use an xlr to 1/4 cable for my mic on my pa800, now I have the pa3x and use the xlr input on the 3x, howver the other day when I used the input on the 3x for the mix, it didn't work. Is there a specific setting I have to adjust to use the input on the 3x for the mic

karmathanever · Post by **karmathanever** » Mon Jan 13, 2014 3:17 am

I assume you've checked the obvious - volume, input level, mute parameter, VP output channeling (audio outs) etc....?
Just asking before going any further to assist...

Pete

Gianul · Post by **Gianul** » Mon Jan 13, 2014 10:32 am

Take in consideration that if you use a mic that requires phantom power, you have to activate this function from audio input menue!!!

omarnawabi · Post by **omarnawabi** » Fri Jan 24, 2014 6:51 pm

karmathanever wrote:I assume you've checked the obvious - volume, input level, mute parameter, VP output channeling (audio outs) etc....?
Just asking before going any further to assist...

Pete

Hey ya i ve tried everything i am using a 1/4 to xlr input for the mic. MY xlr input on the keyboard works fine but i want to use the 1/4 inputs for the mic like i use to on the pa 800. I tried playing a sampler through the 1/4 inputs on the keyboard and they both work! so can it be the wire or is the korg pa 3x designed so only the mic xlr input is used for mic playback not the 1/4 like in the pa800