Change joystick pitch bend

Dniss · Post by **Dniss** » Fri Mar 16, 2012 6:10 pm

Can't find this one:

On this pgrm I-B051, when I push the joystick to the left, pitch goes down like 3 notes. Where do I increase this value to, say, one octave?

thanks and best regards.

AlchemistMusicStudio · Fri Mar 16, 2012 6:48 pm

INT-B 051: Dyno E.Piano

1. Go to the OSC / Pitch Tab
2. Go to the OSC1 Pitch Tab
3. Press the JS(-X) button

A setting of +60 allows the pitch to be controlled a maximum of five octave upward.
A setting of –60 allows the pitch to be controlled a maximum of five octave downward.

+12 - one octave upward
-12 - one octave downward

Dniss · Post by **Dniss** » Mon Mar 26, 2012 4:15 am

Thanks for your reply! I was away, I will give it a try!

Mikespeed · Post by **Mikespeed** » Wed Mar 05, 2014 7:59 pm

AlchemistMusicStudio wrote:INT-B 051: Dyno E.Piano

1. Go to the OSC / Pitch Tab
2. Go to the OSC1 Pitch Tab
3. Press the JS(-X) button

A setting of +60 allows the pitch to be controlled a maximum of five octave upward.
A setting of –60 allows the pitch to be controlled a maximum of five octave downward.

+12 - one octave upward
-12 - one octave downward

Can this be done to work only on one program? I need more pitch bend for the steel guitar program, but I don't want to change for all programs. Maybe in combi mode?

latnjazfan · Post by **latnjazfan** » Thu Mar 06, 2014 4:18 am

Dniss and Mikespeed

I'd really like to hear this! When you get good at the technique, please post and share your steel guitar sounds efforts here.

Thanks.

jeebustrain · Post by **jeebustrain** » Thu Mar 06, 2014 4:23 am

Mikespeed wrote:
AlchemistMusicStudio wrote:INT-B 051: Dyno E.Piano

1. Go to the OSC / Pitch Tab
2. Go to the OSC1 Pitch Tab
3. Press the JS(-X) button

A setting of +60 allows the pitch to be controlled a maximum of five octave upward.
A setting of –60 allows the pitch to be controlled a maximum of five octave downward.

+12 - one octave upward
-12 - one octave downward
Can this be done to work only on one program? I need more pitch bend for the steel guitar program, but I don't want to change for all programs. Maybe in combi mode?

yes, this change can only be done per program.