Updating fail: Trinity Plus to OS 2.4.1

tiko_y · Post by **tiko_y** » Tue Jul 08, 2014 3:53 pm

Hello,
This is my firt post here.

Yesterday, I tried an updating of Trinity Plus to the 2.4.1 version, but it failed. After the second disk, the key shows that it was successfull, but next, show that the System Checkum failed and it said "try again"... But not happens, the same error message persist.
When I try turn on the key, there is a SYSTEM ERROR msg!
So, only the command for OS updating works. I can't do the Test Mode (enter+5) or Reset command (enter+0).
Someone knows what is happening? Need I remove all expansion boards (SOLO and HDR) before starting?

Pls Help me. Thank you!

tiko_y · Post by **tiko_y** » Wed Jul 09, 2014 12:07 am

Error after update:

https://fbcdn-sphotos-h-a.akamaihd.net/ ... 0b5e66ea05

Error while I try start the key:

https://fbcdn-sphotos-h-a.akamaihd.net/ ... 87fc1ff15c

Timo · Post by **Timo** » Wed Jul 09, 2014 12:54 am

Two thing I can think of, given it's a checksum error. Have you tried:

1) using different floppy disks (one or both may have hardware faults), and...
2) re-downloading the OS from a different source (in case it was a corrupted file)?

tiko_y · Post by **tiko_y** » Thu Jul 10, 2014 4:16 am

Now it's working!

Only bad disks! I tried new ones, and now it's OK!

Timo · Post by **Timo** » Thu Jul 10, 2014 12:22 pm

Good, very good.

Enjoy your Trinity!