Problems with EXBV-256 memory ..Help !!!!!

[Robydur]

. Hello everyone !!!!
  Last week I received a few days ago PA3X and buy MUSIC STORE an EXB-256m. After several attempts to install and I could not do it ... Watch Internet videos, read the manual .. but the keyboard does not recognize the memory board ... someone tell me I'm doing wrong ???
thanks

[Dikikeys]

Did you first make sure you have the latest PA3X OS?

Was the PA3X a new one or used?

Have you checked whether all battery status indicators are OK?

Can you get the store to send you an exchange RAM module?

[Hungnguyen]

i did change mine, it took me about half an hour to figure it out.
So in your case, I will recommend that you need to open and completely un-install or take the 256MB memory card out , and Re-insert it back...Make sure it sit firm and traight before inserting the memory card into the slot. And lock it tight with two lock spring on both side ended.and re-stard your keyboard.

Good luck !

[Dikikeys]

i did change mine, it took me about half an hour to figure it out.
So in your case, I will recommend that you need to open and completely un-install or take the 256MB memory card out , and Re-insert it back...Make sure it sit firm and traight before inserting the memory card into the slot. And lock it tight with two lock spring on both side ended.and re-stard your keyboard.

Good luck !

OP states he has already done this several times...

[AntonySharmman]

but the keyboard does not recognize the memory board ... someone tell me I'm doing wrong ???

Maybe you don't and memory card is defective !

Do the following :
- Plug back the old 128 Mb Ram
- Go to Sound/record/sample edit/ upper screen roll down meny / delete and choose all samples and multisamples.
- Choose info tab and confirm that remaing memory is 1398 seconds which means that your Pa3X has no problem !
- Turn off Pa3X , switch Ram boards (with new 256 Mb Ram) be sure that safety clips are properly closed and turn on Pa3X.
- Go to Sound/record/sample edit/info and there are two occasions :
1. Remaining memory is 2796 seconds and all are fine
2. Remaining memory is 0 and your new Ram module is defected and must be replaced.

[Robydur]

Thanks to all
I did everything right ... but I do not understand what happens ??? After placing the memory 256 ...
the sampling information is:
Mono Time: 1398 s.
Bytes: 134217896
Larguest block: 134217896

.... I think it is not so .....

  I have installed the OS 1.63

any suggestions ???
thanks again

[AntonySharmman]

Do not bother with OS or anything else , it doesn't matter at all ...
If after installing the new Ram module and after : Sound/record/sample edit/ upper screen roll down meny /
delete / all samples and multisamples , info shows 1398 sec of remaining memory then by 99,9 % Ram
module they gave you is 128 Mb and not 256 ...

Demand a replacement !

Hope this helps

PS If you examine ram chips label on board of both Ram modules , you can easily find out if your
new ram module is indeed 256 MB (4 ICs)

[Robydur]

Thanks Antony !!
but the plate is engraved ...
DTL-256 Mb
mistake or deception is Manufacturer
Samsung brand

Tomorrow I claim to MUSIC STORE .. I hope I can change because I am far .. in Argentina