Calling up STS through midi

Rudders · Post by **Rudders** » Tue Nov 10, 2015 11:51 am

Hi all
I want to call up STS from a midi file.
I have set channel 16 to control in the default midi preset.
If i enter pc64 into the channel on the sequencer list view i get a sound change.
I have also tried calling up a style using
cc 0 0
cc32 14
pc 11
this doesnt work and when i save the song and then reload i get different figures.
I am obviously doing something wrong
any advice would be appreciated
Sorry forgot to say it's for pa300

tacman7 · Post by **tacman7** » Tue Nov 10, 2015 3:57 pm

I went looking for the page in the manual but I couldn't find it.

There's a page that details what things can be done with midi. It uses program changes. I was using it to change variations in my sequence.

I'll keep looking...

But maybe someone will post that reference again.

Thoraldus · Post by **Thoraldus** » Tue Nov 10, 2015 4:45 pm

Page 198 of the PDF PA600 User Manual

tacman7 · Post by **tacman7** » Tue Nov 10, 2015 9:46 pm

Thank You, thank you very much.

Does it have the same page in the PA300 manual?

I was using the key editor in Studio One, I added a program change lane and had it send out 85, then 87 etc. to change variations at certain times.

That was on ch 5 that I set to control in the global midi input settings.

Thoraldus · Post by **Thoraldus** » Tue Nov 10, 2015 10:52 pm

tacman7 wrote:Thank You, thank you very much.

Does it have the same page in the PA300 manual?

I was using the key editor in Studio One, I added a program change lane and had it send out 85, then 87 etc. to change variations at certain times.

That was on ch 5 that I set to control in the global midi input settings.

Page 360 in the PA300 User Manual

Rudders · Post by **Rudders** » Wed Nov 11, 2015 8:12 pm

Thanks for all the advice.
The problem I have is that I don't seem to be able to create a control channel.
I have set channel 16 midi in to control in the default preset but in sequencer mode channel 16 seems to be an ordinary channel.