Bass

mjustind77 · Post by **mjustind77** » Thu Jun 30, 2016 5:56 pm

how do I adjust pitch on certain hits. Other than the knob. So, I'll push a couple hits in and sometimes them shits come in extremely high. Or low sometimes. I can't figure out how or why.

Anyone experience this?

two505s · Post by **two505s** » Thu Jun 30, 2016 6:06 pm

If some pitches are very high some low you're probably somehow changing the Octave knob/function. Are you hooked up to MIDI?
What happens if you make a sequence of 16 the same notes? It still happens?

Or is your LFO maybe on pitch mode?

mjustind77 · Post by **mjustind77** » Thu Jun 30, 2016 6:37 pm

Hello,

Thanks for your response.

I am running midi. All 16 steps. So, M4 and M6 with VCO3, no matter when I put the pitch knob. How would I change the octave for just these two? Not sure how I got myself in to this. haha

mjustind77 · Post by **mjustind77** » Thu Jun 30, 2016 6:40 pm

Super strange. I think you were right. At least in part. I was messing with the LFO and using FUNC and hit the two steps at the same time, I think, and they dropped back to being controlled by pitch knob. Not sure if it was just that issue. Or a combination but your input got me there.

Thanks!!

mjustind77 · Post by **mjustind77** » Thu Jun 30, 2016 6:42 pm

ahhh it has something to do with VCO Group. All the 3 VCO on in the 3rd VCO Group. The one under M3

two505s · Post by **two505s** » Thu Jun 30, 2016 8:45 pm

Erm.. glad I could help