NanoKontrol 2 volume is actually a pitch bend

ilwoody · Post by **ilwoody** » Wed Mar 06, 2019 12:29 pm

Hello, I just bought and configure the nanoKontrol2 with Cubase 9.5 Artist

It works fine a part from the volume button that does not trigger the mixer volume of a specific track, but the pitch bend.

How do I swicth so that it can control the volume?

Thank you

voip · Post by **voip** » Wed Mar 06, 2019 9:30 pm

Was the nanoKONTROL2 connected to the USB port whilst the SET MARKER and REW buttons were pressed, and has it been set up as Mackie Control in the Device Settings, and NanoKONTROL2 for MIDI In/Out ports?

ilwoody · Post by **ilwoody** » Sat Mar 09, 2019 11:57 am

voip wrote:Was the nanoKONTROL2 connected to the USB port whilst the SET MARKER and REW buttons were pressed, and has it been set up as Mackie Control in the Device Settings, and NanoKONTROL2 for MIDI In/Out ports?

Yes sir I did all of that. Actually I saw no messages or alert when I plugged the controller while pressing the buttons, so I cannot really say I was pressing properly, but I mean... How many way there could've been.

If I'll try again, should I reset any feautures, like disable mackie control or anything else?

Thanks for helping.