Been trying all day to set this up, watch a ton of utube videos .
I want ot use the NanoKontrol Studio as a CC controller asnd use CC learn, in WIN 10, Cubase 11.
Currently, I have the US driver installed. It's 8th port in the list in the unistall utlity - so this should be good.
In Cubase, a Mackie Control is set up to default values and shows the Nano as MIDI inputs and Outputs.
In MIDI Setup, the ports are active and ticked . I have tried "In all MIDI" as both ticked and unticked.
I can see activity in the trasport bar generated by moving faders in the USB connected Nano, but no MIDI learn is happening.
Frustrated!
What gives folks! ????
Z
Nano Kontrol Studion woes!
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
Hi,
I can not help on Cubase settings. But you could install MIDI-OX and to monitor the NanoKontrol and see whether CC messages are received when moving sliders and pushing buttons. At least you can rule out the device itself.
Good luck
I can not help on Cubase settings. But you could install MIDI-OX and to monitor the NanoKontrol and see whether CC messages are received when moving sliders and pushing buttons. At least you can rule out the device itself.
Good luck
microKORGXL, Kaossilator Pro, monotribe, SQ-1, volca fm, Kross 88 BK
Alesis SR18, Akai Miniak, Fender Strat, Line 6 Spider II 112, Zoom MS-50G
Alesis SR18, Akai Miniak, Fender Strat, Line 6 Spider II 112, Zoom MS-50G