I've acquired a used M3 61 with the Radias board but no cable - they are not available anymore but I can make one, I just need a photo of both connectors on the cable itself.
Seems the header on the EXB board my be a bespoke one...
Can anyone help out?
Photo needed of Radias EXB cable
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
-
pax-eterna.1
- Senior Member
- Posts: 393
- Joined: Wed May 03, 2017 7:13 pm
The images in the link below might help a bit.
https://reverb.com/item/52083814-korg-e ... ing-screws
The cable seems straightforward enough. Measure the connector pin spacing on the board as accurately as possible, and also the connector on the M3 itself. Find the pin 1 reference on the silk screen printed on the EXB-Radias PCB and also the M3 connector.
The connector on the M3 is a Samtec part, STMM-110-02-G-D-SM-K-TR, which is 2.0mm pin spacing, so look for the mating IDC (insulation displacement connector). Check that the connector on the EXB-Radias is the same. The ribbon cable will need to be 1.0mm spacing.
.
https://reverb.com/item/52083814-korg-e ... ing-screws
The cable seems straightforward enough. Measure the connector pin spacing on the board as accurately as possible, and also the connector on the M3 itself. Find the pin 1 reference on the silk screen printed on the EXB-Radias PCB and also the M3 connector.
The connector on the M3 is a Samtec part, STMM-110-02-G-D-SM-K-TR, which is 2.0mm pin spacing, so look for the mating IDC (insulation displacement connector). Check that the connector on the EXB-Radias is the same. The ribbon cable will need to be 1.0mm spacing.
.