First two projects I have to do with this new Kross 2 involve an entire tune in 3/4- shouldn't be hard to set as the time signature but I can't figure it out. The second involves 4/4 with a bar of 7/8 before the B section - don't expect that to be easy but there must be someone out there that does tunes in something other than 4/4 and uses one of these boards.....
Help ......please....?
Kross 2 Time Signature setup in sequencer
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
-
Dan Stesco
- Approved Merchant
- Posts: 677
- Joined: Fri Dec 11, 2009 9:10 am
- Location: Bucharest
- Contact:
HI
Please select the REC page. (In SEQ mod three page right).
Arm the REC. Press rec button to prepare to REC. The time signature will be */*. Now move the cursor to signature and change the signature as you need to rec. The procedure work for each measure separately. So if you want to change the signature from measure 32, just start to rec from 32 and change the signature again.
Good luck
Please select the REC page. (In SEQ mod three page right).
Arm the REC. Press rec button to prepare to REC. The time signature will be */*. Now move the cursor to signature and change the signature as you need to rec. The procedure work for each measure separately. So if you want to change the signature from measure 32, just start to rec from 32 and change the signature again.
Good luck
-
LittleWhite
- Posts: 5
- Joined: Wed Sep 27, 2017 7:23 pm
-
pincho1974
- Posts: 1
- Joined: Fri Jan 06, 2023 10:35 am
Time signature korg kross
And how to set the time signature when creating or editing an arpeggio pattern?
-
Dan Stesco
- Approved Merchant
- Posts: 677
- Joined: Fri Dec 11, 2009 9:10 am
- Location: Bucharest
- Contact:
Arp patterns time signature is different concept.
For example to write 6/8 will need to select 12 steps and adjust the step to 8Th. Also parameters as Swing could add the different balance between steps.
The simple 4/4 could be write as 16 steps and set the dot one at 4 steps for 4'th, one at two steps for 8'th and one dot for each steps for 16'th. The value of notes could be adjust in the Arp parameters after save as well.
For example to write 6/8 will need to select 12 steps and adjust the step to 8Th. Also parameters as Swing could add the different balance between steps.
The simple 4/4 could be write as 16 steps and set the dot one at 4 steps for 4'th, one at two steps for 8'th and one dot for each steps for 16'th. The value of notes could be adjust in the Arp parameters after save as well.