Failed update V2.10

jasimud · Post by **jasimud** » Fri Dec 25, 2020 8:30 pm

Hey!

I'm having some troubles with my new Minilogue XD. I tried doing an update to the V2.10 with my mac. Everything was going fine but at some point during installation an error popped up, I think it was Error 1000 or something like that.

After that the updater stopped but the minilogue was in the same state "Recieving update", after a while I rebooted it and it started but I'm not sure if something is broken or not. Also now if I try to do a "Factory reset" i get a "Data Error" and I can't do it!

Any ideas?!

Ryan0751 · Post by **Ryan0751** » Sat Jul 13, 2024 8:09 pm

I know this is a very old post, but I have just noticed this myself.

My XD module is on firmware 2.10, and same thing when I try to factory reset: "Data Error".

I can't find any other information about this error.