Page 2 of 4
Posted: Thu Apr 19, 2018 9:38 pm
by CharlesFerraro
<iframe src="
https://www.youtube.com/embed/MlAl9Fmx0Qc?ecver=2" width="640" height="360" frameborder="0" allow="autoplay; encrypted-media"></iframe>
Posted: Thu Apr 19, 2018 11:27 pm
by CharlesFerraro
<iframe width="560" height="315" src="
https://www.youtube.com/embed/sT-qTrWFCpU" frameborder="0" allow="autoplay; encrypted-media"></iframe>
Posted: Fri Apr 20, 2018 2:32 am
by CharlesFerraro
WS1, I should've checked what would happen if I were to layer two samples in one oscillator. I also should've checked what would've happened if I used both oscillators in HD-1. Maybe someone here can answer how those changes would effect the sound if at all.
<iframe width="560" height="315" src="
https://www.youtube.com/embed/RQqL7rBUQjE" frameborder="0" allow="autoplay; encrypted-media"></iframe>
Posted: Tue Apr 24, 2018 7:04 pm
by CharlesFerraro
<iframe width="560" height="315" src="
https://www.youtube.com/embed/rOtYJVA2c_A" frameborder="0" allow="autoplay; encrypted-media"></iframe>
Posted: Fri May 04, 2018 7:00 am
by CharlesFerraro
The manual says the Transpose parameter is prior to the notes going into the GE. But it doesn't point out that it is one of the last transformations in the "signal chain" so to speak. When forcing the range of the input notes in the Control group (next video) the transpose parameter can then transpose the results up or down to any octave (or semitone) you want, instead of just centering on octave 3. I go over this detail in the next video.
<iframe src="
https://www.youtube.com/embed/IUjviEQurB4?ecver=2" width="640" height="360" frameborder="0" allow="autoplay; encrypted-media"></iframe>
Posted: Sat May 05, 2018 10:39 am
by CharlesFerraro
<iframe src="
https://www.youtube.com/embed/Eu3to0Y2rH4?ecver=2" width="640" height="360" frameborder="0" allow="autoplay; encrypted-media"></iframe>
Posted: Sat May 05, 2018 1:10 pm
by CharlesFerraro
<iframe src="
https://www.youtube.com/embed/HSwY5V2uo08?ecver=2" width="640" height="360" frameborder="0" allow="autoplay; encrypted-media"></iframe>
Posted: Sun May 06, 2018 5:35 am
by CharlesFerraro
<iframe src="
https://www.youtube.com/embed/I-14fTEGHv8?ecver=2" width="640" height="360" frameborder="0" allow="autoplay; encrypted-media"></iframe>
Posted: Sun May 06, 2018 6:29 pm
by CharlesFerraro
There is a bug here if you have your delay start on an eighth note when you enable KARMA. The bug makes it so you can't use smaller note values for the delay start and if you use larger values like a quarter note, the result will be a delay start that is enabled a quarter
and eighth note after you hit a trigger.
<iframe width="560" height="315" src="
https://www.youtube.com/embed/SwjeSpPPMP4" frameborder="0" allow="autoplay; encrypted-media"></iframe>
Posted: Sun May 06, 2018 8:55 pm
by CharlesFerraro
<iframe src="
https://www.youtube.com/embed/RExkqVhHIQs?ecver=2" width="640" height="360" frameborder="0" allow="autoplay; encrypted-media"></iframe>
Posted: Mon May 07, 2018 10:16 pm
by CharlesFerraro
<iframe src="
https://www.youtube.com/embed/IqTsR-vDU3E?ecver=2" width="640" height="360" frameborder="0" allow="autoplay; encrypted-media"></iframe>
Posted: Wed May 09, 2018 7:53 pm
by CharlesFerraro
<iframe src="
https://www.youtube.com/embed/qMfHAvN9wYc?ecver=2" width="640" height="360" frameborder="0" allow="autoplay; encrypted-media"></iframe>
Posted: Thu May 10, 2018 6:27 pm
by CharlesFerraro
<iframe src="
https://www.youtube.com/embed/SsETNb0lvZ8?ecver=2" width="640" height="360" frameborder="0" allow="autoplay; encrypted-media"></iframe>
Posted: Thu May 10, 2018 7:22 pm
by CharlesFerraro
<iframe src="
https://www.youtube.com/embed/LdeBKEW-KmU?ecver=2" width="640" height="360" frameborder="0" allow="autoplay; encrypted-media"></iframe>
Posted: Fri May 11, 2018 10:53 am
by CharlesFerraro
<iframe src="
https://www.youtube.com/embed/f9uvzBdapoE?ecver=2" width="640" height="360" frameborder="0" allow="autoplay; encrypted-media"></iframe>