Korg Forums

The one I was trying to say is that imported PCG from Pa2X maybe suspect for this bug
and not imported samples and multisamples !
I don't face such an issue even clients of my commercial sets therefore I can't be more specific in yours.

You need also to find out which group may cause this problem erasing groups of sounds, Drumkits & Performance (after saving your Set) and restarting to test loading time !

Thanks again for your advices, that will be a hell of a work to do (time consuming).
I hope Korg comes up with a solution to this, pretty fast.

I can confirm: I've a multisample load that brings loading time over ten minuts. I've downloaded it, so I cannot say if it was produced on PA2X or PA3X.

Hi,

We are aware of a problem with slow loading samples in some situations, and we are after it. We are further investigating on this matter, but please do not bring your Pa3X to the Service Center before we come out with further notice.

We apologize for this inconvenience, and look forward to have a solution soon.

Best, Paolo

Vex, you have a personal mail.
Best, Paolo

I just reply. Did you get the message?

tramannoni wrote:Hi,

We are aware of a problem with slow loading samples in some situations, and we are after it. We are further investigating on this matter, but please do not bring your Pa3X to the Service Center before we come out with further notice.

We apologize for this inconvenience, and look forward to have a solution soon.

Best, Paolo

Hi Paolo,

Do you have any news about the loading time. Right now I have 1073 sec of sampling time available, and my loading time is 23 minutes, yes 23.
I am not confortable using my PA3X on stage, because I would have to make people wait 23 minutes before we get back into the party. And yes power failures have happened even in the very best halls and hotels.
Please advise ASAP.

Thanks a 100000000000

Ciao Paolo, you say "in some situations": we can do something to not be in these situations? Or it is a dysfunction related to the number of samples loaded? Thanks for the answers you give.

I am wondering if a solution to this problem has been found?

We'll have to wait for new OS to see is there any improvements on that field.

I can also confirm, that 128mb of samples takes about 7min to load. My pa3x is brand new 1 week old. This is ridiculous. I also did the test with battery out just to see if it makes any difference, and it does not. Battery saves you maybe a minute the most.

Does this start happening after you compress the samples?

redfox wrote:we can do something to not be in these situations? Or it is a dysfunction related to the number of samples loaded?

It depends on a mix of factors, that are unfortunately impossible to collect on a limited set of rules. We are working on it, and it will be solved in the next OS release.

Paolo

An important issue that can cause delaying while loading PCM data was recently
discovered during sound development on Pa3X.

Advanced users might have noticed that sharing a common sample with more than
one multisample creates index conflicts of multisamples with result of sample
loss on exporting as KMP file.
The same conflict happens while loading multi addressed sounds of a sample
shared multisamples from a xxx.SET , common samples are lost or invalid !
This issue comes a step beyond in delaying PCM loading on Pa3X as I recently found.

Therefore try not to share the same loop or sample sound with more than one multisamples ,
this seemed to be one of important reasons to delay PCM preloading in Ram or Pa3X start up.
In that case it's important to duplicate common samples and allign then to each multisample.

Therefore try not to share the same loop or sample sound with more than one multisamples

That's quite an extremely odd thing to do anyway. No wonder KORG didn't catch this during beta testing.

Regards
Sharp.