Page 3 of 3
Posted: Thu May 04, 2017 4:45 pm
by keith-helen
Hi All
Just to inform, that when I was playing this tone the sound went on and on (i.e sustain did not stop) It was then I realised that the polarity on my sustain pedal had changed. so when I pressed it down the sustain ceased.
It maybe just me?
Regards
Keith
Posted: Thu May 04, 2017 6:30 pm
by KONNECTORAS
keith-helen wrote:Hi All
Just to inform, that when I was playing this tone the sound went on and on (i.e sustain did not stop) It was then I realised that the polarity on my sustain pedal had changed. so when I pressed it down the sustain ceased.
It maybe just me?
Regards
Keith
Did you change pedal?
Some pedals that have reversed polarity need recalibration.
Posted: Thu May 04, 2017 6:43 pm
by keith-helen
Hi KONNECTORAS
I can change the polarity, not a problem.
Its just that it was working correctly before I loaded this sound.
As I said its not a problem its just strange.
Many thanks though for replying.
Regards
Keith
Posted: Thu May 04, 2017 7:03 pm
by KONNECTORAS
Did you load the sound as a single sound, or the whole set at once?
Posted: Thu May 04, 2017 7:44 pm
by keith-helen
Hi
whole set.
Its easier
Best wishes
Keith
Posted: Thu May 04, 2017 7:50 pm
by KONNECTORAS
It seems that you loaded a new Global as well.
That is why the Dumper pedal calibration changed.
Posted: Sat May 06, 2017 11:30 am
by jm2a
Hello
on my Pa4X after Unzipping the file I get an error message saying "this is not a pa file! when opening User.01
anything wrong ??
Posted: Sun May 07, 2017 9:48 am
by Bernie9
QUOTE FROM PETE
Daniel has included the SAMPLES multisamples and SOUND for you within the SET
Just "open" the SET and then "open" the SOUND - now select the sound and load it as an individual sound - the samples will load with it.
Or you can just simply load the whole SET but this will overwrite your SOUND bank (think it was USER01) "
I copied the whole set to HD and loaded it. Now I can't find it. I supposed I would see it loaded to my Set Library in user section.
Bernie