Korg Forums

Hi there.
I use an WIN-XP and WIN7. Both work perfect with Kevin Goodmann Trinito and my TR-Rack.
Only Problem - I cannot open any downloaded *.PCG as always the above mentionend file error appears.
Taking my onboard sysex to trinito shows no problem, working on the sounds and bringing them back to the unit - perfect ! BUT - and this p... me off - I cannot open any foreign files due the error message.

Any ideas to help me out

congratulations on getting trinitro to work im on windows 7 and never could get it to work for me , so im using sound diver v3.0.5
maybe i should try again

i dont know how to transfer sounds(pcg files) tho, sorry let us know how it works out for u

Maybe you can try in PCG Tools if the type is correct (e.g. a Triton Extreme PCG file).

Hi and sorry for late reply. Had a surgery which was quiet nasty - however, still alive but same Korg problem.
I tried as followed:
- opened a file from the internet with several editors - worked, but cannot open these in Trinito
-- opened my file from my TR-rack with these editors - not working (header failure) but works with Trinito
--- opened both files with PCG Tools - both working.

However, think I found the failure.
The internet files are allocated to : Studio Rack
My files from my TR integrated with Kevin Goodman Trinto have the allocation: Trinity V2

An image to these different allocations are to be found here:
https://www.dropbox.com/s/k3ld22drvpd0c ... g.jpg?dl=0

Any ideas how to fix this, so that I can upload the internet files to my TR.

Thanks for help

Greetings from Athens Greece
Win 7 32bit.
Trinitro is installed...and the I have a continuous message appears..access violation code 00006....

Is there any solution for this?

2. I am tyring to use PCG Tools. It works fine..but when I generate any selection...nothing happens.

I use Korg tr rack...after 15 years...and I feel newbie.

Finally, where the new pcg install in Tr rack?

Thank you in advance

Korgious wrote:Greetings from Athens Greece
Win 7 32bit.
2. I am tyring to use PCG Tools. It works fine..but when I generate any selection...nothing happens.

What exactly you mean with 'generate any selection'?

Nor wrote:Why do I get this error message after several use of Trinitro?

access violation at address 00000006. read address of address 00000006.

I run Windows 7 Ultimate.

Because it is Windows 7. I get that too. So I switched to older laptop with XP.
Maybe you want to install XP if possible.

Does anyone know whether PCGTools (or anything else for that matter) would work in Win10? I'm too long in the tooth to battle with recalcitrant software!
I recently picked up a Trinity, thinking to use it as a MIDI controller, but have come to like it in its own right ...