The New Electribes

hoolak · Post by **hoolak** » Mon Dec 22, 2014 6:54 pm

Not had mine too long, but I did update to 1.03 and heard a dramatic difference. Before it would have a small almost glitchy unseamless transition, but now, changing patterns seem seamless.

hoolak · Post by **hoolak** » Mon Dec 22, 2014 7:14 pm

I wish there was an oscillator waveform graphic that visually feeds back the changes you are making when turning the Oscillator Edit knob.

I'm not sure what's happening when I turn it, say on a simple sawtooth.

roblabs · Post by **roblabs** » Mon Dec 22, 2014 8:43 pm

hoolak wrote:I wish there was an oscillator waveform graphic that visually feeds back the changes you are making when turning the Oscillator Edit knob.

I'm not sure what's happening when I turn it, say on a simple sawtooth.

why not connect it to an oscilloscope?

hoolak · Post by **hoolak** » Mon Dec 22, 2014 9:12 pm

I have one in work. I might just do that.

hoolak · Post by **hoolak** » Tue Dec 23, 2014 10:33 am

Anyone know if there is a way to copy and paste from say bar 1 to bar 2, or am I limited to whole part copy/pasting?

sharps030 · Post by **sharps030** » Thu Dec 25, 2014 9:34 am

hoolak:

write a 1 bar pattern. Then, expand the pattern length out to 2 or 4 bars - you should have the same 1 bar pattern copy/pasted 2 or 4 times.

hoolak · Post by **hoolak** » Thu Dec 25, 2014 9:57 am

I know that, what I meant to say is retrospectively. So, if I already have the pattern set to 4 bars, how can I do it then?

DrHoo · Post by **DrHoo** » Thu Dec 25, 2014 10:46 am

hoolak wrote:I know that, what I meant to say is retrospectively. So, if I already have the pattern set to 4 bars, how can I do it then?

Not possible as far as i ca tell but why would you want to ? There are sequencer punch buttons to copy your measures with & if it's a melody you only have 4 bars to record anyway !