Korg Forums

Hi I currently have my SQ1 connected to my MS20 mini as per the Korg instruction and works perfectly.

I would like to have the A part for the ms20 mini and the B part for the monotribe.

I have a split out cable and the monotribe in CV mode with 1 on, 2 on and step 3 on in cv setup mode.

However when i play the SQ1 the monotribe sounds but has no pitch variation, it also is responding what appears to be output A to despite being connected to B cv/gate.

Some assistance would be appreciated as the SQ1 has opened up the ms20 nicely.

I only found 1 video of the sq1 controlling the Monotribe and it doesnt5 say in the Korg SQ1 FAQ how to set it up with the monotribe.


regards

verify the cable works at the MT by taking the Gate and Keys out from the 20 direct to the MT - ensure you're sure what is the gate and what is pitch, it'll help you ascertain the polarity is right and that the Hz/v is set right on MT - if not make sure you calibrate teh MT with reference voltages from the 20 - then try again
.
many modes are just mirroring A to B so check you have what you expect on SQ1
drive the sq1 with the MT sync/clock to keep them together

I made a new cable and now I have control of pitch and note value. How do I calibrate the monotribe with the SQ1 as the cv setup wants me to play note C4?