Korg Forums

Hi, my Trinity seems to be only outputting the basic CC's: notes, after touch, etc... I have set the Global Midi Filters in the options to 'all' and the trinity seems to accept midi CC's from my DAW. I've looked every where in the global and sequencer settings and can't find a solution.

On, a related note. Does anyone know if you can edit the Trinity via another controller like the Behringer BCR-2000? Editing the Trinity with an external controller would make things so much easier. I've tried before to setup my BCR to edit the Trinity but the Trinity would not accept any of the controller messages.

Is it even possible to edit the Trinity in depth with a midi controller? If you can edit it with a controller is it possible to control the Trinity parameters in real time?


Thanks in advance!

Ribbon is tricky - it can be a HW failure. If so, you'll need a tech.

If you have all your patches and combis (and all else) saved safely, then you can try the factory diagnostics (probably you'll find on this forum somewhere the key combination to enter). If your ribbon fails to work there, then you're very likely to have a HW failure...

Good luck!

synthjoe wrote:Ribbon is tricky - it can be a HW failure. If so, you'll need a tech.

If you have all your patches and combis (and all else) saved safely, then you can try the factory diagnostics (probably you'll find on this forum somewhere the key combination to enter). If your ribbon fails to work there, then you're very likely to have a HW failure...

Good luck!

Thanks. I will try that.