How to setup AMS source Knob Mod Properly?

onetlittle · Post by **onetlittle** » Sat Jun 24, 2017 7:13 pm

Hey Im new to the Forum so Hello everyone

My Question:

How can I setup the Knob Mod 5-8(Those are the User 1- User 4 Hardware Knobs right? ) to control any AMS Source? When I select them in, for example, IFX section to increase the effect input, it does'nt change anything, although i selected Knob Mod 8 at AMS and put Amount to +99.

Anything i have to do additionally?

Greetings

amit · Post by **amit** » Sun Jun 25, 2017 5:28 am

You need to be in RT mode on control surface for these knobs to work.

onetlittle · Post by **onetlittle** » Mon Jun 26, 2017 5:53 pm

amit wrote:You need to be in RT mode on control surface for these knobs to work.

THANK YOU!!

Wasnt explained properly in the 1000+ pages Manual

, or i didnt find it