Korg Forums

I recently bought an electribe sampler 2 and had a go a making some patterns. I noticed my patterns seemed slightly off beat. So to test this I input a very simple sequence of a 4/4 kick with a clap on every 2nd beat. I noticed there was a minor delay between the kick and clap sound being played although they are both supposed to be triggered at the exact same time. I understand that the electribe is automatically quantised to each of the 16 pads and quantisation can't be turned off but don't understand why 2 sounds that are supposed to be triggered at the same time have a delay between them. All the latest firmware is installed and I have been using the factory sounds sounds. Can anyone point me in the right direction of what I can do to fix this?

Thanks

Are u using swing or any of the grooves?

Look at the kick and clap kick and clap wav-files in an editor, there may be a gap before the actual sound start.

Z7A wrote:Look at the kick and clap kick and clap wav-files in an editor, there may be a gap before the actual sound start.

I agree. Also, the fadein (attack) time may be longer on the kick. To verify, try to put the clap on both parts. They should be synchronized.

Z7A wrote:Look at the kick and clap kick and clap wav-files in an editor, there may be a gap before the actual sound start.

He said he's using the factory sounds so this would not apply.

My guess would be the groove templates.