Page 1 of 1
Help needed for PCG Tools for Kross 2
Posted: Thu Sep 28, 2017 10:30 am
by michelkeijzers
For letting PCG Tools support the new Korg Kross 2, I need some help. I found one PCG file for the Kross 2 and I managed to change PCG Tools so it can be read, but there are some things to solve. However, I need someone who owns a Kross 2 to make some small justifications in a Kross 2 file and send the changed version, possibly it needs to be repeated a few times. It cost probably in total 1-2 hours, but that means that everyone can use PCG Tools with the Kross 2. Please let me know.
Posted: Sun Oct 01, 2017 10:46 am
by synthjoe
I'd love to help you but my Kross2 has to wait a little...
Maybe until Christmas...?
Posted: Sun Oct 01, 2017 7:10 pm
by michelkeijzers
synthjoe wrote:I'd love to help you but my Kross2 has to wait a little...
Maybe until Christmas...?
I hope for you, you will get it sooner.
Someone is willingly to help, not sure how well this will end up though.
Posted: Fri Oct 06, 2017 8:29 pm
by Dan Stesco
Hey Michel,
I made factory voicing for KROSS 2 and I would like to help. Please tell me what can I do for you.
Best,
Dan
Posted: Sat Oct 07, 2017 8:35 am
by michelkeijzers
Dan Stesco wrote:Hey Michel,
I made factory voicing for KROSS 2 and I would like to help. Please tell me what can I do for you.
Best,
Dan
Thank you very much ... I will write an email!
Posted: Fri Oct 20, 2017 10:45 pm
by highlandstudio91
Dan Stesco wrote:Hey Michel,
I made factory voicing for KROSS 2 and I would like to help.
Dan
Hello Dan,
I am a former Krome owner & was looking forward to buying your expansion libraries for it,but ended up returning 2 defective Kromes.
That said,I placed an order for a Kross 2 and was wondering if you will be making expansion sets for it?
The specs on both read the same(except for more PCM data on the Kross 2),so perhaps I would just buy the original expansion libraries for the Kross 2?
Thanks