Page 1 of 1
Midi commands
Posted: Sat Dec 16, 2017 1:53 pm
by Rocknout4u
Ok this sending midi commands to the krome is wearing me down trying to figure out what you need to send to change from program mode to combination mode .I am using a Korg moxF in master mode which controls up to 4 external synths and using zone 2 to send bank change and program changes to the krome .i put a number from 1-6 in the LSB to change banks and then just put the number 1-128 in the program change area in the moxF to change to the right program.Can you change from a program bank to a combination using a midi command and if so what would you have to do ? I have researched and looked all over and can't find any info on this .Anyone have any ideas . Thanks
Posted: Sun Dec 17, 2017 3:04 am
by jcw
It is possible to tell Krome to change from program mode to combi mode and back using sysex message. The code is in the back of the parameters manual...and in this forum somewhere...a search should locate it.
Posted: Sun Dec 17, 2017 3:09 am
by Rocknout4u
I know this can be done from a pc or mac but no way to send those commands from a Synth to another Synth .
Posted: Sun Dec 17, 2017 1:52 pm
by Rocknout4u
Not sure why I did not think of just using the combi mode and not using program mode and sending the program changes to it .I will set my krome up for my live sets in combi mode .
Posted: Sun Dec 17, 2017 5:54 pm
by voip
Set List mode allows Programs, Combis, and Songs to be combined in the Set List, and then selected via external MIDI command.
Posted: Sun Dec 17, 2017 8:21 pm
by Rocknout4u
The Korg Krome doesn't have setlist mode only the Kronos has that
Posted: Sun Dec 17, 2017 8:59 pm
by jcw
Rocknout4u wrote:Not sure why I did not think of just using the combi mode and not using program mode and sending the program changes to it .I will set my krome up for my live sets in combi mode .
Good thinking....I was just going to suggest that...all the best
Posted: Sun Dec 17, 2017 9:11 pm
by voip
Sorry. Forgot this was the Krome list.