Arp triggering question
Posted: Thu May 17, 2018 7:26 am
I have a a problem with triggering arps with EXT timbers. I am using a combi, where I have zone 1 for internal choir sound. Then zone 2, for running arpeggios to external synth.
Setup:
Zone 1. one timbre INT
Zone 2. one timbe EXT with channel 2. one timber OFF with channel gch. both set to arp A.
And the problem:
When I press a key from Zone 2, arp is triggered as expected and everything works. BUT. When I'm playing something from Zone 1 and at the same time press a key from Zone 2, arp does not work.
Any ideas why?
Setup:
Zone 1. one timbre INT
Zone 2. one timbe EXT with channel 2. one timber OFF with channel gch. both set to arp A.
And the problem:
When I press a key from Zone 2, arp is triggered as expected and everything works. BUT. When I'm playing something from Zone 1 and at the same time press a key from Zone 2, arp does not work.
Any ideas why?