Korg Forums

Hi,

I try to start a sound from scratch - is there any way to initialize a single program before editing?

Could not find anything about that in the manuals...

Ser

Okay, that is the solution I found ... working on 01/wfd ..

1. Reset the synth (Comp+Reset+PowerOn).
2. Write Combi/Progs to Disk
3. Load Factory defaults (Global->Page7->Load)

If you now want any Prog or Combi to be Init - select Prog or Combi.

Load single Prog/Combi from Disk.


Of cause there is the way with a midi editor ... but I did not test it yet.