Page 1 of 1

Pa 4X main board fault

Posted: Sun May 05, 2019 1:21 pm
by Georgeymc
Hi All, I'm having an issue with my Pa 4x......I used it Thursday without issue at a wedding ceremony and then Sat went to use it and I have an unusable low audio output. When i say unusable I mean to say its there and I can hear it with headphones but its not hot enough for it to work with a PA. I've just installed the new Next os and nothing has changed. Any insights and help would be greatly appreciated. Philip

Posted: Sun May 05, 2019 3:14 pm
by karmathanever
Hey Philip

Do you get the same low audio from the headphones?

Pete :D

Posted: Sun May 05, 2019 6:22 pm
by Georgeymc
karmathanever wrote:Hey Philip

Do you get the same low audio from the headphones?

Pete :D
Yeah....so low that it’s barely audible over the noise of the keys, but it is there and all functions are operating correctly

Posted: Sun May 05, 2019 6:29 pm
by seaside
Is the MAXX master EQ turned on with VOL +2 ? Terry

Posted: Sun May 05, 2019 6:52 pm
by Georgeymc
I’ll check that now Terry thanks

Posted: Sun May 05, 2019 6:57 pm
by Georgeymc
seaside wrote:Is the MAXX master EQ turned on with VOL +2 ? Terry
Yes it’s on and set at 2.0. When I play a note the “out” level indicator hits approx 25

Posted: Fri May 17, 2019 1:51 pm
by Georgeymc
update.....the problem was hardware, a local engineer had to remove 3 chips from the main board individually before he found the culprit. FYI P

Posted: Fri May 17, 2019 2:26 pm
by Asena
I hope it,s ok Now, Thats realy bad, but it,s Electical stuf and can happen some times, God luck.