Page 1 of 1
Korg Kronos 2 88 Front Fender Replacement
Posted: Thu Apr 30, 2020 3:30 am
by omkar.sunkersett
Where do you buy a new front fender for the Korg Kronos 2 88 if the front fender has a dent?
Posted: Thu Apr 30, 2020 8:27 pm
by JFree
Rockauto.com
Posted: Thu Apr 30, 2020 8:50 pm
by average_male
JFree wrote:Rockauto.com
Not cool. Guy is looking for help, not abuse.
Posted: Fri May 01, 2020 1:32 am
by GregC
If I understand I think the part is an end cheek to the chassis.
if you have a K2 my guess its wood
Posted: Fri May 01, 2020 2:56 am
by omkar.sunkersett
@GregC,
I am talking about the front metal bar that covers the keybed assembly on the K2 88.
I looked online and it is out of stock everywhere.
Posted: Fri May 01, 2020 9:00 am
by voip
How bad is the dent? Can it be knocked out? Automobile panel beaters can do amazing things with bodywork.
.
Posted: Fri May 01, 2020 11:11 am
by omkar.sunkersett
voip wrote:How bad is the dent? Can it be knocked out? Automobile panel beaters can do amazing things with bodywork.
.
You got to be kidding lolz. Here is a photo of the dent —
https://drive.google.com/file/d/11aHOD_ ... p=drivesdk
Posted: Fri May 01, 2020 11:32 am
by voip
Hmm, that's a very strange image format!! Nothing to see here. Not running Win10, so needed conversion to .jpg.
The dent in the image would not be a problem for an auto repair shop.
.
Posted: Fri May 01, 2020 2:29 pm
by Sweat
Have you tried this place. Not sure if this is the correct part since there is no image available, but you could contact them.
https://www.partsisparts.net/catalog/ko ... 0642000032
Posted: Fri May 01, 2020 3:55 pm
by GregC
I am unclear on the exact problem.
Is the k2 a recent purchase and was it presented as ' new ' ?
If so, you have a case against the seller or store.
Posted: Fri May 01, 2020 5:28 pm
by omkar.sunkersett
GregC wrote:I am unclear on the exact problem.
Is the k2 a recent purchase and was it presented as ' new ' ?
If so, you have a case against the seller or store.
It’s a lightly used Kronos2-88. I was given a partial refund for the dent to purchase a new front bar.
Posted: Fri May 01, 2020 5:35 pm
by omkar.sunkersett
Posted: Fri May 01, 2020 5:45 pm
by average_male
I had a similar issue and cut out a wooden mold to match the bumper angles /profile (external and internal) and pressed it with bench vise (and hammered the wooden block profile a bit) back into shape. Came out really good, but does take a bit of patience and little bit of skill or luck.
Nothing to lose given the item is OOS at the moment.