EMX-1 AllFl Ld Error (2021) SOLUTION FOUND!!!

[barcini]

I recently replaced the problem fuse (fuse 1) on my classic blue EMX-1, but now when I boot it up I get the AllFl Ld Error. This error is not in the manual and does not respond to diagnostic tests.

I see a few posts on this forum about it, but they are all old and none of them have fixes. Does anyone know a fix for this error or what causes it? I haven’t been able to find a solution anywhere.

UPDATE: As far as I can tell this is basically an error of death for the machine. No information on how to fix it and no information on what it even means.

UPDATE UPDATE: This is caused by a loose connection with the circuit board! Simply cleaning those contacts and retightening the piece that hold the connection in place (looks like piece of circuit board held on my two screws). Good luck!