filter bypass (as described in the manual) where?

[donelectro]

how do I bypass the filter?
the manual lists bypass as an option, but it's just not there

[donelectro]

Multi Filter -> All On might be the way

[RobustAmerican]

Yea the multi-filter has a percentage mixer with a "dry" parameter. Set the others to 0% and the dry signal to 100%.

This sets the filter type for Mode 1.
LPF, HPF, BPF, and Band Reject are the standard filter types. For more information, see “Filter,” on page 36.
LP+BP, LP-BP, LP-HP, BP+HP, BP-HP, Dry+LP, Dry-LP, Dry+BP, Dry-BP, Dry+LP-HP, Dry+LP-BP, Dry+BP-LP,
Dry+BP-HP, Dry+HP-LP, Dry+HP-BP, LP+HP+BP: These combine two or more filters at equal volumes. Dry is the
un-filtered input signal. The minus sign (“-”) indicates when the phase of a filter is reversed.
All On uses the Low Pass, High Pass, Band Pass, and Dry signals at equal volumes.
Manual lets you create your own mix of the filters; an additional four parameters will appear. For more information,
see “Manual,” below.

[donelectro]

from the manual:

Type (FILTER TYPE)
[Bypass, 2-pole LPF, 2-pole HPF, 2-pole BPF,2-pole Band Reject, 4-pole LPF, 4-pole HPF, 4-pole BPF, 4-pole Band
Reject, Multi Filter, MS-20 LPF, MS-20 HPF, Polysix]

[RobustAmerican]

Yea I know, I saw that in the manual too but in the synth?

Bypassing it with the method I use...Setting the percentages of each filter in the multi, still allows you to modulate things later should the need arise.