Page 1 of 1
Can Assignable knob 1 or 2 control all 3 upper sounds?
Posted: Sun Nov 20, 2022 7:59 pm
by moebrand
Hi everyone,
I was wondering if there is a way to assign one of the knobs 1 or 2 to control the volume of all 3 upper sounds at the same time .
As you know Some keyboard sounds contain 3 layer sounds and they can get louder then the styles and accompaniment tracks , I know that the balance knob could be used to adjust the sounds , but it doesn’t sound good enough .
Thanks!
Re: Can Assignable knob 1 or 2 control all 3 upper sounds?
Posted: Wed Nov 23, 2022 1:17 pm
by siebenhirter
moebrand wrote: .. to control the volume of all 3 upper sounds at the same time ..
The Upper Sound volume sliders can be linked together, to proportionally change all Upper Sounds with a single slider, after you have selected the Upper Volume Link checkbox (Mixer/Tuning > Volume/Pan --> manual page 156).
Re: Can Assignable knob 1 or 2 control all 3 upper sounds?
Posted: Wed Nov 23, 2022 10:15 pm
by BR
moebrand wrote:Hi everyone,
I was wondering if there is a way to assign one of the knobs 1 or 2 to control the volume of all 3 upper sounds at the same time .
As you know Some keyboard sounds contain 3 layer sounds and they can get louder then the styles and accompaniment tracks , I know that the balance knob could be used to adjust the sounds , but it doesn’t sound good enough .
Thanks!
I don't have anymore Pa1000 but as I remember you can assign the Volume
of all Upper1,2,3 to an Assignable knob.
Of course you should check mark (as siebenhirter mentioned) Upper Volume Link.
PS: In Pa1000 there is only Virtual sliders no physical sliders.
Posted: Sun Nov 27, 2022 10:15 am
by moebrand
Thanks guys ! That worked .
Cheers!
Volume Settings in PA1000
Posted: Mon Dec 19, 2022 11:47 pm
by hirenkg
1. Why volume changes for the pads before starting a style and after starting a style? How to increase pads volume.
2. What situation would you prefer to do linkable tones versus individual once, and how to increase upper3 volume and lower chord volume using knobs-as only 1 and 2 are controllable via knob?
3. Is it possible so that tone volume that are set do not change before style is started and after it is started? or It is expected behavior.
press shift
Posted: Mon Feb 06, 2023 11:08 pm
by duby2
like the pa4x one slider can do this just by press shift and move just one slider . will do the same as the Upper Volume Link checkbox..
the pa1000 has no slider . but the on screen slider work the same way ...
just saying .