Kronos 2 sends unwanted control change message
Posted: Wed Dec 14, 2022 4:46 pm
Hi, I have a Kronos 2 that control a Roland Integra 7.
In sequenser mode on the Kronos I have an issue that one of my songs seem to send a control change message that sets the Integra 7 Reverb Send value on all parts in the Studio Set that correspond to MIDI channel 1 to the value 127 each time I select that particular sequenser song. The song also sends program change that I have set up so the correct studio set is chosen on the Integra as soon as I select that particular song on the Kronos.
In the MIDI settings tab of the specific Studio Set on the Integra 7 I have disabled all RX messages except Hold/Damper message. And even if I uncheck all check boxes (except program change message filter) in all of the three MIDI filter tabs in the MIDI Filter/Zones tab on the song track on the Kronos that send on MIDI Channel 1, the Reverb Send value on the Integra 7 still changes to 127 as soon as I select that song on the Kronos. This issue only occurs in one of my songs. I have tried to compare this "problematic" song with other songs on the Kronos that don't cause this behaviour but I just can't notice any differences at all how the MIDI TX settings are configured when I compare.
What on earth are causing this control change message getting sent to the Integra 7 ???!!
In sequenser mode on the Kronos I have an issue that one of my songs seem to send a control change message that sets the Integra 7 Reverb Send value on all parts in the Studio Set that correspond to MIDI channel 1 to the value 127 each time I select that particular sequenser song. The song also sends program change that I have set up so the correct studio set is chosen on the Integra as soon as I select that particular song on the Kronos.
In the MIDI settings tab of the specific Studio Set on the Integra 7 I have disabled all RX messages except Hold/Damper message. And even if I uncheck all check boxes (except program change message filter) in all of the three MIDI filter tabs in the MIDI Filter/Zones tab on the song track on the Kronos that send on MIDI Channel 1, the Reverb Send value on the Integra 7 still changes to 127 as soon as I select that song on the Kronos. This issue only occurs in one of my songs. I have tried to compare this "problematic" song with other songs on the Kronos that don't cause this behaviour but I just can't notice any differences at all how the MIDI TX settings are configured when I compare.
What on earth are causing this control change message getting sent to the Integra 7 ???!!