My ARP Odyssey module is not generating any sound through the main outputs or headphone output jacks. I completed the troubleshooting recommendations in the manual. I have switched midi cables and tried all 16 channels using two different controllers. The VCA Gain is at 50% and the LFO Frequency light is flashing.
Has any other ARP Odyssey owners encountered this situation and can you provide some direction for a remedy. Thanks in advance for your help.
Korg ARP Odyssey Module - No Sound
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
Korg ARP Odyssey - No Sound
Yes, the unit has worked OK in the past. I used the Basic settings configuration outlined in the manual for testing. There is no audible “pop” at headphone jack when powering on & off. I have the Odyssey low output going into the Kronos external audio input.
I just adjusted the front panel switches & sliders as suggested but still not getting any sound from the Odyssey. Thanks, I appreciate the timely response.
I just adjusted the front panel switches & sliders as suggested but still not getting any sound from the Odyssey. Thanks, I appreciate the timely response.
Has the unit been in storage, or unused for a while?
In a working system, the sound made at the output during power on or off might be just a slight pop or click, but if nothing is heard. this could indicate an issue with the VCA board, or a poor connection somewhere.
With this in mind, it might be worth cleaning the output jacks (plugs and sockets) with an electrical contact cleaner, like Servisol Super 10, or its Deoxit equivalent. Spray some on the plug, insert/remove the plug into the socket several times, and also give it a few twisting motions. Remove the plug, wipe with a tissue to see what comes off, and repeat the procedure a few more times.
Another thing to try, if possible, is to try passing an external audio signal (roughly at line level) into the ARP Odyssey's Ext Audio Input jack, to see if it makes it through to the output. Doing this will bypass several circuits, so may help to narrow down the issue.
.
In a working system, the sound made at the output during power on or off might be just a slight pop or click, but if nothing is heard. this could indicate an issue with the VCA board, or a poor connection somewhere.
With this in mind, it might be worth cleaning the output jacks (plugs and sockets) with an electrical contact cleaner, like Servisol Super 10, or its Deoxit equivalent. Spray some on the plug, insert/remove the plug into the socket several times, and also give it a few twisting motions. Remove the plug, wipe with a tissue to see what comes off, and repeat the procedure a few more times.
Another thing to try, if possible, is to try passing an external audio signal (roughly at line level) into the ARP Odyssey's Ext Audio Input jack, to see if it makes it through to the output. Doing this will bypass several circuits, so may help to narrow down the issue.
.
Yes the unit was in storage for 2 years. I plugged another synth into the external input. I wasn’t able to hear the audio generated from the second synth. However, I started getting a faint sound at headphone output by adjusting the VCF Frequency. After a few more tweaks the unit is providing full sound through the Low output & into the Kronos. However the headphone output is dead. I will try clearing the output jacks as suggested. Thank you for all your help.