Issue with Korg Volume pedal & PA 800...
Posted: Thu Sep 27, 2007 9:28 pm
Hello everyone:
I use the Korg XVP10 volume pedal to control the PA800 and the Tyros2.
Before that, I used 2 Yamaha FC7s, and work fine, BUT, I had to carry 2 pedals, I saw the solution with the XVP10, so, I could use ONE volume pedal for both keyboards.
The XVP10 pedal works PERFECT with the Tyros2....not with the Korg PA 800...is does not goes smooth from PP to FF...pianisimo to Fortisimo....is like jumping steps and even missing some....in the T2 works just fine.
Is strange that the same manufacturer is not as compatible among itself, and rather works BETTER with a competitors keyboard brand.
I hope Paul or someone in Italy check that out, is really bad. And just for the record, you have to use cables with ring and tip 1/4 inch plug in both ends, I have change 3 times BRAND new cables, and is not the cables....nor the output on the pedals...I switched the keyboards and still the same problem with the PA800.
I use the Korg XVP10 volume pedal to control the PA800 and the Tyros2.
Before that, I used 2 Yamaha FC7s, and work fine, BUT, I had to carry 2 pedals, I saw the solution with the XVP10, so, I could use ONE volume pedal for both keyboards.
The XVP10 pedal works PERFECT with the Tyros2....not with the Korg PA 800...is does not goes smooth from PP to FF...pianisimo to Fortisimo....is like jumping steps and even missing some....in the T2 works just fine.
Is strange that the same manufacturer is not as compatible among itself, and rather works BETTER with a competitors keyboard brand.
I hope Paul or someone in Italy check that out, is really bad. And just for the record, you have to use cables with ring and tip 1/4 inch plug in both ends, I have change 3 times BRAND new cables, and is not the cables....nor the output on the pedals...I switched the keyboards and still the same problem with the PA800.