Page 1 of 1
Help with using the Pa1Xpro as a midi controller
Posted: Sun Sep 30, 2007 3:08 pm
by Insight
When using the Pa1Xpro as a midi controller, the sounds change on the keyboard that I have connected to the midi out on the Pa1Xpro.
Is there a way to disable the midi channel for the "Single Touch Settings" buttons to prevent the sounds from changing on the connected instrument?
Posted: Sun Sep 30, 2007 4:39 pm
by Rob Sherratt
I think you can disable program changes from being transmitted via MIDI Out. It will be in the Global -> MIDI settings somewhere. When you find it please post an update?
Best regards,
Rob
Posted: Sun Sep 30, 2007 5:25 pm
by Insight
I've looked and cannot find anything to disable program changes.
Is the program change transmitted on the same channel?
I was hoping I could change the midi channel for program changes.
Posted: Sun Sep 30, 2007 10:02 pm
by Insight
I found a work around. On the Hammond XB-2, that is connected to the midi out of the Pa1Xpro, I had to go into settings and turn ON the PROGNO (Program Number Filter) to disables the preset changing when selecting the "Single Touch Settings" buttons on the PA1Xpro.
There still should be a way to disable that on the Pa1Xpro if your using it as a midi controller and also using the sounds in the Pa1Xpro.