Page 1 of 1
Nedim: how does pcm stay after turning off keyboard?
Posted: Wed Oct 31, 2007 7:44 am
by soga
Hello Nedim,
In a previous post you stated that the PCM would remain on the keyboard even after shutting off and turning on.? How does this happen without having to load PCM again? (PA800)
Every time I restart, I have to re-load PCM.....
Posted: Wed Oct 31, 2007 8:44 am
by BasariStudios
If you go to MEDIA MODE and then PREFERENCES in there is a BOX and
next to it says PCM AUTOLOAD, check that BOX and SAVE.
Next time when you turn the synth on even if you have a 67MB set inside
it turns on in less then 90 seconds.
Posted: Wed Oct 31, 2007 1:50 pm
by soga
Hi Nedim,
I know about the auto load feature..it's just that in that previous post you mentioned that the PCM would remain in memory even after shutting off...so I thought there was a way of not having to re-load it...manually or auto load.
Posted: Wed Oct 31, 2007 2:05 pm
by BasariStudios
Soga, when you turn the synth on it is not loading it, do you understand that?
PA800 just turns on with the samples and everything in less then 90 seconds.
If you try to LOAD the same set its gonna tke you 20 minutes.
Get it now? The PCMs are still inside.