Korg Forums

Dear Mr.Tramannoni:

I have the MASTER TRANSPOSE locked as stated on page 213 of the latest manual. When I send the GM2 system exclusive"Control Transpose"
the Pa800 will not recognize the "master transpose sysex" when received via MIDI.
However, when I unlock the Master Transpose then it works. This is not logical and to me it is a bug in the OS v1.51.


I am sending this GM2 Master Transpose system exclusive message:

[F0 7F 0g 04 04 vv mm F7]

Any one from Korg is able to give an answer to this strange behaviour?

i just tested this issue with an older OS dated Nov 06, 2006. It does work fine when you lock the Master Transpose and the Pa800 is receiving the midi data for the Transpose.

Is Korg going to issue an update to fix this bug?