Page 1 of 1
Realtime controls in "B" Modus on MicroX
Posted: Sun May 25, 2008 2:30 pm
by Ganlog
Hey guys. Seem to be very stupid (maybe because of going out long yesterday night) but in the manual and also otherwise I can't find out how to change the assignable controls 1-4 in "B" mode?
I can see on the display Knob "B" 1-4 on the bottom of the menu but don't know how to jump to the changeable parameters.
Can any one help?
Thanx.
Grees Ganlog
Posted: Sun May 25, 2008 8:59 pm
by Bigs
Do you mean the 'Controls' page (at the far right) of the 'Arp/Control' section (which kan be reached using the menu button)?
Posted: Mon May 26, 2008 7:09 am
by Ganlog
hello bigs
No there's nothing about the arp. My english isn't very clear maybe. When I selected "B" in the realtime controls section on the right side of the micro x I just want to define which parameters are changed when I use the control knobs 1-4 .
Unfortunately I don't know how I can put a picture into this post. Do you understand now?
Thanx for the answer...
Grees Ganlog
Posted: Mon May 26, 2008 2:36 pm
by Bigs
Ok, step by step then:
- Choose a program
- Press 'menu'
- Choose 'Arp/controls'
- Press Page+ two times to go to the 'controls' tab
- Use the clickpoint and/or wheel to change the settings
For combinations it's the same, only you have to flick through some more pages.
Posted: Mon May 26, 2008 7:23 pm
by Ganlog
hey bigs thanx a lot. I found out now and makes me happy. I found it in the manual too now.
grees Ganlog