Sequence recording problem/question...

[Gorilla]

I have an issue when recording in the Pa1X. Scenario: I have recorded thirty measures. Using the Locate section I want to resume recording again at measure thirty-one.
Problem: The instruments fail to record at thirty-one.
Question: What can I do to continue (resume) recording after recording a half of the song. Is there a way to resume recording once stopped?

[tommy1340millar]

Al -
1 possible 'round the houses' type of solution, is to pick an empty track, give it the same sound as you want to record. Start from measure 1 and 'pick-up' the song as it passes the measure where your previous part finished. This would have the effect of lenghtening your existing song, and you could merge the relevant tracks once you've finished.

If you're trying to extend a backing sequence type song, then sadly, I've no idea (I'm not sure it's possible on a pa1x?)

[Gorilla]

Thanks Tommy. I could never figure out why that possibility could not be performed. I know I have other means of continuing i.e., Cubase SX4, but it would have been nice to pickup recording at a certain location on the Pa1X. Thanks.