Page 1 of 1
ESX 1Help
Posted: Fri Jul 18, 2008 3:12 pm
by Gilbatron
I know this sounds really lame but is there a really simple way to copy your pattern/ make it longer without entering every note?
For example if you start with a 1 bar loop how do I copy that to a 4 bar loop without entering every single part?
I am sure this is really simple but I cant work it out.
cheers
Posted: Fri Jul 18, 2008 3:55 pm
by 11hz
save (write) your 1 bar loop. Then Save go back change the length to 2 bars and save that. then go back and change the length to 4 bars and save that. It sounds like alot of steps but it just takes 2-3 seconds to do.
Posted: Fri Jul 18, 2008 7:03 pm
by supermel74
11hz wrote:save (write) your 1 bar loop. Then Save go back change the length to 2 bars and save that. then go back and change the length to 4 bars and save that. It sounds like alot of steps but it just takes 2-3 seconds to do.
Why not just save your 1 bar loop as a 4 bar loop. I don't understand why you would save it as a 2 bar loop first.
Posted: Fri Jul 18, 2008 8:01 pm
by travisthered
supermel74 wrote:11hz wrote:save (write) your 1 bar loop. Then Save go back change the length to 2 bars and save that. then go back and change the length to 4 bars and save that. It sounds like alot of steps but it just takes 2-3 seconds to do.
Why not just save your 1 bar loop as a 4 bar loop. I don't understand why you would save it as a 2 bar loop first.
If you want it to go
A A A A
do it your way, if you want it to go
A B A B
do it 11hz's way.
Posted: Sat Jul 19, 2008 9:18 am
by supermel74
travisthered wrote:supermel74 wrote:11hz wrote:save (write) your 1 bar loop. Then Save go back change the length to 2 bars and save that. then go back and change the length to 4 bars and save that. It sounds like alot of steps but it just takes 2-3 seconds to do.
Why not just save your 1 bar loop as a 4 bar loop. I don't understand why you would save it as a 2 bar loop first.
If you want it to go
A A A A
do it your way, if you want it to go
A B A B
do it 11hz's way.
I'm not following. If it's the exact same loop how is it different either way?
Posted: Sat Jul 19, 2008 4:44 pm
by travisthered
supermel74 wrote:travisthered wrote:supermel74 wrote:Why not just save your 1 bar loop as a 4 bar loop. I don't understand why you would save it as a 2 bar loop first.
If you want it to go
A A A A
do it your way, if you want it to go
A B A B
do it 11hz's way.
I'm not following. If it's the exact same loop how is it different either way?
If it is the exact same loop (A A A A) then it isn't different. You can just write at a length of one and then change it to 4.