Page 1 of 1
My WAV file samples are pretty quiet on the ESX-1
Posted: Tue Jul 22, 2008 12:36 pm
by jdmmade
Hey there, I just needed help for a second, my .WAV files are a bit quiet on the ESX do I just need to raise the amplification of the sound file itself or do I need to raise it in the ESX, which leads to another question. When going to the init section to make a new pattern why do the drums samples sound so quiet compared to the factory drum patterns? Is there anyway to change that so that the sound is much louder?
Posted: Tue Jul 22, 2008 4:02 pm
by zalo
normalize and if that isnt enough you can boost the sample 12 db
look in the appendix of the manual for instructions
Posted: Sun Nov 02, 2008 9:29 am
by gilbertati
how can i boost the sample 12 db??
Posted: Sun Nov 02, 2008 4:02 pm
by Yatmandu
Check to see if you have a recent version of the firmware on your ESX, the last two versions have this, so installing the latest version will enable this feature. The instructions should be available at Korg's site or here somewhere.
Posted: Mon Nov 03, 2008 8:42 am
by supermel74
gilbertati wrote:how can i boost the sample 12 db??
Quiet Samples
Posted: Fri Dec 26, 2008 6:14 pm
by 808state
Its always a good ideo to boost your samples up to +12 Db....
the samples will be loud when you audition them,but turn the volume down on the boosted +12 DB samples when dropping them into a pattern,and you will be very happy with the results.
I have loaded alot the 808,909,and 707 sounds into the esx,all boosted to +12db and the results were excellent,im not a fan of normalisation....