sounds editing

samsonp · Post by **samsonp** » Wed Sep 17, 2008 5:22 pm

hi all.. i was wonder how you guys make new patches from radias?

as lot of the preset sounds that comes with the radias are already all setup with amazing crazy LFO settings and stuff like that..

i was wonder how i can set everything back to normal and use it as a basic sound for me to do my creation?

i hope i have explain it well enough for someone to get a feedback for me.

or is there any program that i can use to make new patches for radias other than the program that comes with it?

Daz · Post by **Daz** » Wed Sep 17, 2008 5:30 pm

The last bank of Programs are called "Init Prog" or similar and those offer you the best starting point for creating new Programs.

meatballfulton · Post by **meatballfulton** » Thu Sep 18, 2008 1:08 pm

There are also Templates which are basic examples of things like basses, strings, pads, etc. that you can use as starting points for your own patches.

Each template is a single timbre, just copy it into an Init Program and off you go.

Read pages 33 and 165 in the manual.