Page 1 of 1
Radias gives distorted reverb
Posted: Tue Sep 23, 2008 3:22 pm
by SIDX8580
Hi since a day or 3 my radias gives distortion on the master reverb
even toug all the volumes ar in the mid the reverb still sounds distorted
it doenst always does that but only on bass patches.
any people here that have the same?
Posted: Wed Sep 24, 2008 1:20 am
by slammah2012
No. My Radis is full Rverbes wiht no ditsortin...
Posted: Wed Sep 24, 2008 1:51 am
by Grapite
I have to ask, is the distorted sound coming through live outputs as well as headphones?
Regards
Posted: Wed Sep 24, 2008 1:43 pm
by gdh
no issues on mine - owned it since they first came out.
Posted: Wed Sep 24, 2008 3:46 pm
by Timo
Are you overdriving the volumes somewhere? There are several in series: Amp levels, Mixer levels, and Drive for each patch internally, and the main Volume knob externally. Also the EQ and filters (particularly with higher resonances) could easy distort the sound if piled on. Various effects could too.
Posted: Wed Sep 24, 2008 11:52 pm
by slammah2012
Timo wrote:Are you overdriving the volumes somewhere? There are several in series: Amp levels, Mixer levels, and Drive for each patch internally, and the main Volume knob externally. Also the EQ and filters (particularly with higher resonances) could easy distort the sound if piled on. Various effects could too.
I explained in an earlier post that I felt the Radias had a low overhead in the amplifier range...
If you jam it in any portion , you will hear some artifacts if you pass that point in the output stage........most likely from to many simulated amplifier stages...I find the phones amp is kind of cheap myself, and the mains are much cleaner...
but yes .....there is amps at the pre filter mixer, post filter, bass/treble EQ,
main timbre volume drive/waveshape before it goes through the amps in the DSP/FX section....finally master volume....
I wished there was an update to get the compare led to flash at clip level....or a clip indicater on the LCD.....