Korg Forums

Hi folks. I am trying to route different loops into my outboard mixer and coming into a problem.

I basically want to use L/R and 3/4 as 4 single mono outputs and then take them to my mixer. Parts coming through 3 and 4 I pan hard left or hard right to go to either channel 3 or 4 on the mixer. This is fine, but one channels L/R panning does not seem to work. If I pan hard left there is leaking on the right channel, and if I pan hard right the left channel still plays.

Am I doing anything wrong? do I need to change anything?

thanks.

Chris

You're doing nothing wrong, I'm afraid it could be a problem with your unit itself.
The strange thing is that you pan hard right and the left channel still plays?!

I'm guessing it could be a problem with the routing to the tubes or the tubes itself because output 3&4 work normal and they are not processed thru the tubes.
Hope this makes sense

How is your stereo balance on output 1-2? Right in the centre or more to the left?

seems centered to me.

I have noticed a persistant hiss coming through the unit through, even with the valve gain turned right down.

thanks

how is your unit hooked up.... this is kind of a long shot, but if you're hooking up through the headphone jack some plugs make it mono. Could it possibly be running in mono?

Hi. I have have four 1/4" mono jacks coming out L/R/3/4 individually. Nothing in anything else.

thanks

the left channel on my ESX leaks over into the right channel when i pan hard left. The left also seems to be always louder by 1 to 2 decibels no matter what i play.
.....Never noticed this before, than again i didnt have a DBX compressor hooked up to my ESX like i do now. Either its my compressor setting or some faulty RCA's.
Hopefully its my RCA's.