If I have a standard synth and I have a BPM of 125. for every 1/4 beat I would like my synth to go from lets say 0-100. So basically it Fades from no sound to sound every 1/4 beat. How do I manage this? Much help would be greatly appreciated.
I would perfer to do this with Volume how ever Filter wouldn't be to bad. But it I have the res turned up at all then well it will clash with filter.
Filter or Volume FX help
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
-
Senor Rappz
- Posts: 2
- Joined: Thu Dec 25, 2008 12:51 am
I think the easiest way would be to use a sawtooth LFO.
of you're using all your LFOs, a step sequencer could also do it.
for the LFO:
set the wave to sawtooth,
set the tempo-sync on,
set the sync rate to 1/4 notes
route the LFO to volume with a free virtual mod patch, and set the amount to +63 (or less if you want to have a less pronounced effect).
there is also a tremolo FX, and the step sequencers, which you could use to achieve a similar effect but i'm not at my radias right now to try these out and explain in more detail for you...
of you're using all your LFOs, a step sequencer could also do it.
for the LFO:
set the wave to sawtooth,
set the tempo-sync on,
set the sync rate to 1/4 notes
route the LFO to volume with a free virtual mod patch, and set the amount to +63 (or less if you want to have a less pronounced effect).
there is also a tremolo FX, and the step sequencers, which you could use to achieve a similar effect but i'm not at my radias right now to try these out and explain in more detail for you...
-
Senor Rappz
- Posts: 2
- Joined: Thu Dec 25, 2008 12:51 am