Page 1 of 1
M50 88 and Roland DP8 half damper pedal
Posted: Fri Jul 03, 2009 11:10 pm
by RonRaymo
Any reason why this wouldn't work on the M 50?
Are all Half dampers created equal? Nobody has the Korg pedals locally.
I was lucky to find the Roland DP8 for under ten bucks and it works.
Although looks like I might have to recalibrate it after power up.
Posted: Sat Jul 04, 2009 1:28 am
by McHale
you've done the half damper calibration? It should stick if you saved your global data when you were done...
-Mc
Posted: Sat Jul 04, 2009 2:27 pm
by RonRaymo
Well it looks like it looses the calibration after shutting down. So I'll have to get the Korg DS 1H pedal. Page 228 of the M50 Parameter guide warns of the sensitivity and that other pedals might not work the same. So for now I switched the roland DP8 to on/off mode and set polarity to + on the M50
Thanks for the reply
Posted: Sat Jul 04, 2009 3:47 pm
by McHale
Have you saved the Global Parameters after calibrating? You can make changes all day but none of them will stay if you don't save them.
-Mc
Posted: Sat Jul 04, 2009 5:46 pm
by RonRaymo
Assuming that write changes is how you save them I did that. on both pages.
Posted: Sat Jul 04, 2009 5:54 pm
by McHale
weird. Than I have no clue. If it worked and you saved, it should work when you power it back on. That's really all there is to it.
Wish I could get my hands on it to play with it. Sorry I can't help...
-Mc
Posted: Sun Jul 05, 2009 1:47 am
by lwasnesky
Something must have been done wrong during the save.
I have the Roland pedal for my X50 and it works fine. The calibration saved without issue and it worked when I powered off/on the keyboard. I know you have an M50, but I find it hard to believe the calibration won't save.
Posted: Sun Jul 05, 2009 3:59 am
by RonRaymo
not sure maybe I got a a deffective pedal I go to page 2 set the + then save it / top right pull down write global.
then go back to page 0 and calibrate it then pull down and write global again.