Hi,
I am new to the forum, and this is my last chance of getting help with my issue..
I recently purchased a nanoKontrol which is a great little controller which I want to use for my VJing needs.. but I noticed a huge problem which is that with the nano I can't reliably send 2 (or more) controls to the software simultaneously at the same time. Meaning that if I move 2 sliders simultaneously, only one slider is reliably sent and registered in sw, but the other one just gets stuck.
For example: if I have two sliders moved down (=set to value 0), and then I move both of them all the way up, only one gets reliably to value 127 in software, but the other depends on the velocity of the move = if my move is very quick then the 2nd slider can even remain at 0 value! if my move is somewhat quick then it gets somewhere but not even near 127 value, and if I move both sliders reasonably slow, eventually both get to value 127.
I can reproduce this problem every time! I work on a Apple MacBook Pro 2.4GHz and 4gigs of RAM, with latest revisions of MAC OS X 10.5.7, QuickTime 7.6.2 and I tried this with VJ softwares Modul8 and Isadora, both latest revisions.
I installed the Korg nano USB driver from the support pages, but it didn't help in solving the issue.
I used many controllers before and never had such a problem. I also tried on another MacBook Pro, but the problem remained.
I would be very happy if anyone can suggest a solution to this problem, which frustrates me and prevents me of using nanoKontrol to its full potential.
Thanks and all the best!
nanoKontrol can't reliably send 2 controls simultaneously??
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever