Page 1 of 1
setting up the OASYS as a hardware controller in Logic
Posted: Tue Jul 21, 2009 8:14 pm
by songs52
I'm a newbie in Logic, and hadn't previosuly used my OASYS as a controller. I'm looking at the Control Surface Set up in Preferences in Logic and couldn't figure out where in the Parameters Guide of the OASYS I could find the info. Anyone who has experience with this? I'd appreciate some help. I'm also interested in any tips using the OASYS as a controller in general, and couldn't find a thread regarding that.
Thanks!
Posted: Wed Jul 22, 2009 9:48 am
by Anashwaran
I have made Programs for Cubase and Oasys, so you could get inspired by that and it should not be very different. Have a look under Anashwaran here or in the Oasys Karma-Lab forum
Good luck
Anashwaran
Posted: Wed Jul 22, 2009 9:53 am
by Anashwaran
your remote
Posted: Wed Jul 22, 2009 12:50 pm
by songs52
Anashwaran,
Thanks so much for your prompt reply I'll use this template, adopt it to Logic and get back to you with some feedback. Very kind of you!
Paul
Posted: Wed Jul 22, 2009 12:51 pm
by Charlie
Ah - that would be a nice thing to have!
