Korg Forums

I just got finished programming 8 scenes(128 pads) to correspond to the 128 cells in Battery3. Any suggestions on how I should program the last 8 scenes(scenes 9-16)?........


...i'm transitioning from an mpc2000xl, so i want to make sure i have a good start on being organized.........
.
.
thanks in advance.

There's a preset in one of the editor folders which has the same note accross all the pads with a series of ascending fixed velocities for that note.

This might be useful to you if you want to tweak different velocity controlled parameters for a particular sound in battery or input a more precise velocity controlled groove with it.

Use the all pads button in edit mode to change this one note to something else quickly.

You could also try setting up a similar scene for a control number instead of a note.

DeadVolume wrote:There's a preset in one of the editor folders which has the same note accross all the pads with a series of ascending fixed velocities for that note.

This might be useful to you if you want to tweak different velocity controlled parameters for a particular sound in battery or input a more precise velocity controlled groove with it.

Use the all pads button in edit mode to change this one note to something else quickly.

You could also try setting up a similar scene for a control number instead of a note.

.
.
.
THANKS A MILLION... i'll go ahead and try that.

You mean 16 scenes with the nanopad?

How do you do that?